- Flame-cut 1" thick side frames
- 2-1/2" Diameter stay bars throughout machine
- 1/8" Stainless steel bed
- Two set of 4" wide upper and lower urethane belts to hold bags on
both ends as bags go though hot melt units
- Rotary or saw type flush cut off attachment, customer side
- Bottom pressing section (12' 6" long) made up of 3" wide urethane
belts with 3" diameter weighted rollers for maximum pressing of factory
end
- Cold air blower section, customer side
- Vacuum rotary opener, customer side, 20 diameter with 2 vacuum pumps
- Rotary type string cutter with pneumatic release when not in use.
Automatically cuts string when bag is missed
- Bottom folding unit, factory side
- Complete guides and stands for running easy open string
|
- Customer end of machine mounted on lineal bearing for lateral
movement during length size changes
- 1 Edge guiding system for aligning customer end hot melt to edge of
bag
- 1 or 2 hot air guns for blowing off angel hair
- Two customer choice hot melt applicators with two 8-ft
delivery hoses, two 2-port slot die heads, 1 pattern controller, 2 photo
eye sensors and 1 speed controller
- Control stations at both ends and in middles of machine
- Complete electrics housed in NEMA 4 enclosure
- Jam switches at necessary points
- OSHA approved guards over all drives and hazardous areas
- Necessary circuit breakers and transformers to make machine
compatible with plant voltage
- Bottomer and registration unit will be powered by a 20 HP AC vector
variable speed drive and motor
|